---------------------------------------------
2021-08-20
Version 1.15

- Fixed a bug that caused an overcurrent error for specific devices
---------------------------------------------

---------------------------------------------
2021-05-30
Version 1.14

- Now fully supporting expert mode for icd.control
---------------------------------------------

---------------------------------------------
-
Version 1.13

- Update only for internal testing
- Release omitted
---------------------------------------------

---------------------------------------------
2021-02-19
Version 1.12

- Fixed a bug that caused timing problems when using 61000-4-19 with icd.control
- Fixed a bug that disabled polarity change for DC signals
- Fixed a bug that triggered an overcurrent error which was caused by specific conditions only on specific devices
- Fixed a minor bug on startup that always caused the device to boot into test wizard. The device will now boot according to the selected menu set in Setup
---------------------------------------------

---------------------------------------------
2020-03-05
Version 1.11

- Fixed a bug with the remote port that occured when too many commands were being processed at once.
- Fixed minor GUI issues.
- Fixed USB serial port for newer devices.
- Added trace for stress sensor 2.
- Improved performance of the GUI.
---------------------------------------------

---------------------------------------------
2018-05-22
Version 1.10
Revision K

- minor changes in HV generation; noticable during calibration only; no changes for user
---------------------------------------------

---------------------------------------------
2018-04-10
Version 1.10
Revision J

fixes
- single-shot mode inoperable for extensions other than NSG 4060-1
- adjustment to the amplifier temperature watchdog: due to slow sensor response at higher temperatures the measurement receives an offset in that region
---------------------------------------------

---------------------------------------------
2017-04-10
Version 1.10
Revision I

fixes
- minor changes in probe handling
- improved behaviour when changing from internal DC to AC while test still running
---------------------------------------------

---------------------------------------------
2017-02-06
Version 1.10
Revision E

fixes
- instability issue in test wizard 61000-4-16 sweep test which was introduced with the software version prior to this revision
---------------------------------------------


---------------------------------------------
2017-02-06
Version 1.10
Revision C

fixes
- version 1.10 had issues when going from external DC in negative polarity back to internal AC (and the other way round also)

additional notes:
- to be able to fully use NSG 4060-1 type B and reverting polarity of external DC, it is required to update the MCU firmware to "SV 2.17"
---------------------------------------------

---------------------------------------------
2017-01-27
Version 1.10
Revision B

new
- loop level adjustment via sensor probe now takes control level overdrive and non-linearity of output vs. input into consideration

fixes
- version 1.10 ignored modulation setup in the wizard's 61000-4-19 tests

additional notes:
- to be able to fully use NSG 4060-1 type B and the new sensor port capabilities, it is required to update the MCU firmware to "SV 2.17"
 ---------------------------------------------


---------------------------------------------
2016-12-08
Version 1.10

new: 
- base unit in combination with NSG4060-1 type B can revert polarity (negative voltage) in respect to ground
- base unit configuration can be saved to and restored from USB flash drive
- front sensor port and analog monitoring port can now be utilized as probe for closed loop level adjustment 

fixes
- version 1.09 failed to update the generator when a change in modulation frequency occurred 

additional notes:
- to be able to fully use NSG 4060-1 type B and the new sensor port capabilities, it is required to update the MCU firmware to "SV 2.17"
 

---------------------------------------------

---------------------------------------------
2016-08-18
Version 1.09A

new: 
- base unit is capable of performing remote control to the external DC source CHROMA 62024P (via RS232) 
- base unit can make use of CN EN 60255-26 (selection of coupling paths depending on test severity and also depending on differential or common mode coupling via User port) 
---------------------------------------------